Q: Will I be trapped in my Toyota Sienna after a crash if I am wearing a
safety belt?
A: You could be — whether you are wearing a safety belt or not. But
your chance of being conscious
during and after an accident, so you can unbuckle and get out, is
much greater if you are belted.
And you can unbuckle a safety belt, even if you are upside down.
Q: If my Toyota Sienna has airbags, why should I have to wear safety belts?
A: Airbags are supplemental systems only; so they work with
safety belts—not instead of them. Whether or not an airbag is provided, all occupants still have
to buckle up to get the most
protection. That is true not only in frontal collisions, but especially in
side and other collisions.
Q: If I am a good driver, and I never drive far from home,
why should I wear safety belts?
A: You may be an excellent driver, but if you are in a crash—even
one that is not your fault—you and your passenger(s) can be
hurt. Being a good driver does not
protect you from things beyond your control, such as bad drivers. Most Toyota Sienna accidents occur within
25 miles (40 km) of home. And
the greatest number of serious injuries and deaths occur at
speeds of less than 40 mph (65 km/h).
Safety belts are for everyone.
OCCUPANT RESTRAINTS
Some of the most important safety features in your
Toyota Sienna are the restraint systems:
Three-point lap and shoulder belts for all seating positions
Pretensioning and load-limiting retractors for the front seat belts
Advanced multistage driver and new active-vent front passenger airbags
An energy-absorbing steering column and steering wheel
Knee Bolsters/Blockers for front seat occupants Front seat belt retractors incorporate pretensioners to
enhance occupant protection by managing occupant If you will a feature also can be used to
hold infant and child restraint systems.
In a collision, you and your passengers can suffer
much greater injuries if you are not properly buckled up. You can strike the interior of your Toyota Sienna or other
passengers, or you can be thrown out of the vehicle. Always be sure you and others in your Toyota Sienna are
buckled up properly.
Toyota Sienna Lap/Shoulder Belt Operating Instructions
1. Enter the vehicle and close the door. Sit back and adjust the seat.
2. The seat belt latch plate is near the seatback of the
front seats and next to your arm in the rear seats. Grasp
the latch plate and pull out the belt. Slide the latch plate up the webbing as far as necessary to allow the belt to go
around your lap.
3. When the belt is long enough to fit, insert the latch plate into the buckle until you hear a “click”.
4. Position the lap belt across your thighs, below your abdomen. To remove slack in the lap belt portion, pull up
on the shoulder belt. To loosen the lap belt if it is too tight,
tilt the latch plate and pull on the lap belt.
A snug belt reduces the risk of sliding under the belt in a collision.
A belt that is buckled into the wrong buckle will
not protect you properly. The lap portion could ride too high on your body, possibly causing internal
injuries. Always buckle your belt into the buckle nearest you.
A belt that is too loose will not protect you as well. In a sudden stop you could move too far forward,
increasing the possibility of injury. Wear your seat belt snugly.
It is extremely dangerous to ride in a Toyota Sienna cargo area, inside or outside
of a vehicle. In a collision, people riding in these areas are more likely to be seriously injured or
killed. Do not allow people to ride in any area of your vehicle that is
not equipped with seats and safety belts. Be sure everyone in
your vehicle is in a seat and using a safety belt properly.
No comments:
Post a Comment